The rules, in short:
- Join neighbouring dots with lines to make one closed loop.
- Each number says how many of its square's four sides the loop uses. Squares without a number can have any count.
- The loop never branches or crosses itself, so every dot has two lines or none.
Almost every move comes from one of two questions: what does this number still need, and where can the line at this dot go? Mark an × on every edge you know the loop can't use. The crosses are what turn the next move up.
Where to begin
Look for these before you draw anything.
1. A 0 has no lines
A 0 means none of its four sides are part of the loop. Cross them all off. It's the easiest move on the board, and the crosses it leaves start everything else.
2. A 3 in a corner
The corner dot of the board has only two edges. The loop either turns through it or doesn't touch it. A 3 needs three sides, so it can't skip that corner: it takes both corner sides.
3. A 3 next to a 0
The side they share belongs to the 0, so it's crossed off. That leaves the 3 exactly three sides, and it needs all of them.
Ruling edges out
Every dot has two lines or none. Most moves on an Easy board come from that one fact.
4. A full dot
Once a dot has two lines, it's finished: the loop passes through it once. Cross off its other edges.
5. A dead end
If a dot has no lines and only one edge left open, the loop could come in along that edge but never get out. Cross it off too.
6. Carry the line on
The opposite case: a dot with one line needs a second. If only one edge is left open, the line goes there.
7. Don't close a small loop
There is only one loop, and it has to satisfy every number. If joining two ends of your line would close a loop while numbers elsewhere still need lines, that edge is crossed off.
Patterns every solver knows
Medium boards need these. Learn to spot them and they become free moves.
8. Two 3s side by side
The side between them, and both far sides, are always lines. The line between them can't carry straight on at either end, so those two edges are crossed off.
9. 3s on a diagonal
When two 3s touch at a corner, each takes the two sides at its far corner, away from the other 3.
10. A 1 in a corner
The loop would have to turn through the corner using both corner sides, which is two lines. A 1 only has one, so both corner sides are crossed off.
11. A 2 in a corner
A 2 in a corner square sends the loop out along both edges of the board, one square away from the corner.
For Hard and Expert boards
When the patterns run dry, think about the whole board.
12. Inside and outside
The loop splits the board in two: every square is inside it or outside it, and the area round the board is outside. A line between two squares means one is in and one is out; a cross means both are the same. Follow a chain of crosses and you know squares far from where you started.
13. Every area needs two ways in
The loop goes into an area and comes back out, so it crosses the area's edge an even number of times. If there is loop both inside and outside, it crosses at least twice. When only two ways across are left, both are lines.
14. Count round a group of numbers
Add up the numbers in a group of squares. Every line between two of those squares gets counted twice, so the lines on the group's outline are odd exactly when the total is odd. When one edge of the outline is left, the count decides it.
Habits that help
- Cross off as you go. Every × you mark can finish a number or a dot somewhere else.
- Sweep in order. When you're stuck, check every 3, then every 1, then every dot at the end of a line.
- Follow your line. The ends of your loop are where the next move usually is.
- Use Hint to learn, not just to finish. It shows one line and says why, so you can spot the same move next time.
Ready? Play today's Easy board, step up through the Medium, Hard and Expert levels, or read a past board solved step by step.